Kwik Mix Post Setting Mix - 66 lbs

A perfectly proportioned blend of high quality Portland Cement, Concrete Sand, dry crushed aggregate and a special set accelerator. Suitable for a variety of "fast setting" applications such as the setting of posts and poles. The set time (initial set in approximately 5 minutes) allows for placing and setting without the use of bracing. Each 66 lb bag will produce about ½ cubic foot of finished Concrete. This product does not require mixing. Dig post hole and allow at least 2" of clearance on each side of post. Put 5 or 6" of water in the bottom of the hole and pour KWIK POST dry mix directly into hole around the post until the hole is filled to 4" below grade. Add additional water to the top of the hole while poking with rod or stick to allow water to penetrate into the material. Do not over water! Kwik Post will start to stiffen within minutes, and the post will be load bearing within several hours. Warm water will speed the set time and cold water will slow down the set time. Moisten the exposed surface of the Concrete and slope away from the post to allow water run-off to prevent post rotting.

• Pre-blended and ready to use - Just add water.
• Allows for same day construction of fences and decks.
• Nail and install.
• Exceeds ASTM C-387 specification for strength when mixed according to directions.
• Backed by Independent Quality Control Tests.